Replacing The Control Panel Board - Gateway 7450R System Manual

7
Plug the fan connector into the connector on the system board and
replace the cable in the cable clamps. Make sure the cable does not
interfere with airflow and will not be pinched when you close the cover.
8
Close the case. See "Closing the case" on page 20.
9
Reconnect the power cord and external peripherals, then turn on the
system.

Replacing the control panel board

The control panel board is mounted on the front of the chassis, inside the
front panel.
To replace the control panel board:
1
Turn off the system and disconnect the power cord and all external
peripherals.
2
Open the case. See "Opening the case" on page 18 and "Preventing static
electricity discharge" on page 17.
3
Disconnect all cables from the control panel board. Note the location and
orientation of each cable as you remove it.
4
Remove the three screws that secure the control panel board to the front
of the chassis, then remove the board from the server.
Replacing and Adding Internal Devices
53