Removing The Server From A Cabinet - Gateway E-9525R User Manual

3
4
5

Removing the server from a cabinet

To remove the server from a cabinet:
1
2
www.gateway.com
Back view
Handle
Mounting screw
Mounting bracket
Mounting bracket
Mounting screw
Remove the bezel lock keys from the inside of the bezel, then insert the left side of the bezel
into the left handle and swing the right side of the bezel in until it snaps into place.
When the bezel is in place, lock the bezel by inserting the key into the lock in the lower right
corner of the bezel and turning it clockwise until it stops (approximately ¼ turn).
Put the key in a safe place.
Warning
Screws are required to support the front of the server. You must support the
server while removing the front screws and while sliding the server off the cabinet
rails. If the server is not supported, damage to the server or injury may result.
Remove the thumbscrews through the handles that hold the server in the cabinet.
While supporting the server, slide the server out from the cabinet.
Front view
17