Filling Empty Drive Bays; Installing Memory - Gateway E-9525R User Manual

7
8
9
10
11

Filling empty drive bays

Empty drive bays in the server must be filled by empty drive trays. With the bezel removed, install
the appropriate carrier, then replace the bezel by snapping it into place on the front of the server.
Empty drive carriers for unused drive bays are included with your server.

Installing memory

Your server supports eight 667 MHz fully-buffered DIMMs (FB-DIMMs) to provide up to 32 GB.
Supported DIMM sizes include 512 MB, 1 GB, 2 GB, and 4 GB. DIMMs must be low-profile or ultra
low-profile and cannot exceed 1.2 inches in height.
www.gateway.com
Push the drive tray with the new diskette drive into the opening in the media cage until it
clicks into place.
Connect the USB cable to the back of the diskette drive.
Follow the instructions in
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
Reconnect all power cords and peripheral device cables, then turn on the server.
Caution
Use only 667 MHz Fully-Buffered (FB-DIMM) memory modules.
"Closing the server case" on page 32.
Memory slots
39