Power; Processor - Gateway E-9525R User Manual

Power

You press the power button, but the server does not turn on
•
•
•
•
When you turn on the server, it makes several short beeps
•

Processor

Your server does not recognize a new processor
•
•
84
CHAPTER 6: Troubleshooting
If the power button LED is green, the server is turned on, but you may not be seeing an
image on the monitor. For monitor troubleshooting, see
If your server is plugged into a surge protector or UPS, make sure that the surge protector
or UPS is connected securely to an electrical outlet, turned on, and working correctly. One
way to check this is to plug the server directly into a wall outlet, bypassing the surge protector
or UPS.
Make sure that the electrical outlet is working by plugging a working device, such as a lamp,
into the outlet, then turning it on to test the outlet.
Open your server and make sure that the power supply module cage cable is connected
correctly to the system board.
The short beeps indicate the server has encountered some type of error. See
on page 74.
Make sure that the processor is fully seated in its socket. The processor should be recognized
automatically if it is installed correctly.
If you have upgraded your server from one processor to two, you may need to reconfigure
your operating system so it recognizes the additional processor. For instructions, see your
operating system's documentation.
"Monitor" on page 83.
"Beep codes"