Replacing The Control Panel Bridge Card - Gateway E-9525R User Manual

CHAPTER 4: Installing Components

Replacing the control panel bridge card

60
To replace the control panel bridge card:
Follow the instructions in
1
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Remove the fan duct and system fans by following the instructions in
3
"Replacing system fans" on page
Remove the media cage by following the instructions in
4
installing an optical drive" on page
Disconnect the cables from the control panel bridge card.
5
Remove the top panel screw (1), then loosen the thumbscrew (2) holding
6
the control panel bridge card to the chassis.
Push the control panel bridge card (3) toward the front of the chassis and
7
remove it, then store it in a static-free bag.
Holding the new control panel bridge card by the edges, place it in the
8
chassis, then slide it toward the back of the chassis.
Tighten the thumbscrew to secure the control panel bridge card in the
9
chassis.
Insert the media cage into the assembly bay in the chassis.
10
Secure the assembly by tightening the thumbscrew you previously
11
loosened.
Connect the data and power cables to the back of the drives and the
12
control panel bridge card.
Reinstall the fan duct and system fans by following the instructions in
13
"Replacing system fans" on page 46.
Follow the instructions in
14
"Preventing static electricity discharge" on
"Opening the server case" on page
46.
33.
1
3
2
"Closing the server case" on page
www.gateway.com
31.
"Removing and
32.