Replacing The Control Panel; Replacing The System Board - Gateway E-9425R User Manual

Replacing the control panel

To replace the control panel:
1
2
3
4
5
6
7
8
9
10

Replacing the system board

To replace the system board:
1
2
3
4
5
54
CHAPTER 4: Installing Components
Caution
Your server must be operated with a control panel module in place.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Unlock the bezel (if necessary) and remove it by pulling it straight out from the front of
the chassis.
Disconnect the cables from the control panel.
Push the retaining clips (1) to the open position, then slide the control panel (2) back from
the front of the server to disengage it from the locking tabs and remove it.
Holding the new control panel by the edges, align it with the locking tabs, then place it
on the tabs and slide it toward the front of the chassis.
Push the retaining tabs to the closed position to hold the control panel in place in the
chassis.
Connect the cables that you previously removed.
Follow the instructions in
Replace the bezel by snapping it into place on the front of the server.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the system fans and fan cage by following the instructions in
fans" on page 41.
Remove the PCI riser assembly by following the instructions in
PCI expansion cards" on page
Remove the memory modules by following the instructions in
page 36.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
39.
28. Make sure
29.
30.
28. Make sure
29.
"Replacing system
"Installing and removing
"Installing memory" on