Gateway E-9525R User Manual page 64

14
15
16
17
18
19
20
21
58
CHAPTER 4: Installing Components
Install the memory by following the instructions in
Replace the system fan cage and fan duct by following the instructions in
fans" on page 44.
Install the processor(s) and heatsink(s) by following the instructions in
a processor" on page 47.
Reinstall the PCI riser assembly by following the instructions in
PCI expansion cards" on page
Follow the instructions in
Restart your server, then press F2 at any time after you see the LEDs on your keyboard
flash or turn off. The BIOS Setup utility opens.
Check BIOS settings to make sure that they detect the server's new hardware, then save
your changes (if any) and close the BIOS Setup utility.
If your server does not start after installing the new system board, contact Gateway
Customer Care. For more information, see
42.
"Closing the server case" on page
"Getting Help" on page
"Installing memory" on page
"Replacing system
"Replacing or adding
"Installing and removing
32.
9.
39.