Table of Contents
Advertisement
CHAPTER 4: Installing Components
Replacing the control panel
Your server must be operated with a
control panel module in place.
58
Locate the old battery on the system board and note its orientation. You
6
will need to install the new battery the same way.
Push the battery retention clip away from the battery until the battery lifts
7
up, then remove the old battery. You can use a screwdriver to help lift the
battery.
Make sure that the positive (+) side of the new battery is facing the correct
8
direction, then press the new battery into the socket until it snaps into
place.
Follow the instructions in
9
Turn on your server, then press F2 when the Gateway logo screen appears
10
during startup. The BIOS Setup utility opens.
Restore any BIOS settings that you wrote down in
11
Save all your settings and close the BIOS Setup utility.
12
Caution
To replace the control panel:
Follow the instructions in
1
page
30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Unlock the bezel (if necessary) and remove it by pulling it straight out from
3
the front of the chassis.
Disconnect the cables from the control panel.
4
"Closing the server case" on page
"Preventing static electricity discharge" on
"Opening the server case" on page
www.gateway.com
32.
Step
3.
31.
Advertisement
Table of Contents
Troubleshooting
