Replacing The Control Panel; Replacing The System Board - Gateway E-9722R User Manual

Replacing the control panel

To replace the control panel adapter card:
1
2
3
4
5
6
7

Replacing the system board

To replace the system board:
1
2
3
4
5
6
7
50
CHAPTER 4: Installing Components
Caution
Your server must be operated with a control panel in place.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Disconnect all cables from the control panel.
Press down the two side locking tabs, then pull the control panel back and lift it out of
the chassis
Holding the new control panel by the edges, align it with the locking tabs in the chassis,
then slide it toward the front of the chassis.
Reconnect the cables to the control panel.
Follow the instructions in
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the PCI riser assembly by following the instructions in
PCI expansion cards" on page
Remove the fan duct and system fan cage by following the instructions in
system fans" on page 38.
Remove the memory modules by following the instructions in
page 31.
Remove the heatsinks and processors by following the instructions in
a processor" on page 41.
Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
34.
24. Make sure
25.
27.
24. Make sure
25.
"Installing and removing
"Replacing
"Installing memory" on
"Replacing or adding