Fans" On Page - Gateway E-9525R User Manual

4
Remove the fan duct and system fan cage by following the instructions in

fans" on page

44.
5
Remove the memory modules by following the instructions in
page 39.
6
Remove the heatsinks and processors by following the instructions in
a processor" on page
7
Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
8
Loosen the two thumbscrews (1) that secure the system board to the server.
2
2
1
9
Slide the system board toward the back of the server until it is free of the eight retaining
standoffs (2), then lift the board from the chassis.
10
Place the old system board in a static-free bag for storage.
11
Insert the new system board into the chassis, aligned with the eight retaining standoffs,
then slide the board toward the front of the case so the board is held by the standoffs.
12
Tighten the two system board thumbscrews to secure the board into the chassis.
13
Connect the cables you removed in
www.gateway.com
47.
2
2
2
Step 7.
"Replacing system
"Installing memory" on
"Replacing or adding
2
2
57