Table of Contents
Advertisement
Configuring PCL Printer Driver Properties for Windows
(2) Punch
These settings are available only when the Punch Kit (PK-6) is
installed on the machine. They control the punching of holes in a
document.
• Off
• Auto
• Top
• Left
• Punch Holes
Printer Controller Pi3505e Pi3505e/PS
Note
Stapling may be canceled automatically if a print job is made
up of pages of different sizes.
The stapling position is determined based on the orientation of
the first page of the print job. Remember this when printing a
document made up of pages that are oriented differently from
each other.
Only
Center
can be selected for stapling while
selected on the
Setup
Tip
The current stapling locations are reflected in the graphic icon
shown on the dialog box.
No page punching
Pages are punch along the top edge when
landscape orientation is selected, or along the
left edge when portrait orientation is selected.
Pages are punched along the top edge.
Pages are punched along the left edge.
Specify the number of holes to be punched.
Available settings:
When a PK-6 (2 Holes) is installed: 2
When a PK-6 (2 or 3 Holes) is installed: 2 or 3
When a PK-6 (4 Holes) is installed: 4
tab.
4
Booklet
is
4-15
Advertisement
Table of Contents
