Led Indicators; Connecting The Machine To A Computer; Connecting Directly To A Computer With An Ieee1284 Cable - Konica Minolta Pi3505e User Manual

1

LED indicators

The following displays the meanings of each LED color and status.
LED Color
Green
Red
1.5

Connecting the Machine to a Computer

Important!
Note the following precautions whenever turning off the machine.
G
Never turn off the machine when either of the following conditions
exists.
While the machine is performing some operation
While there is print data stored in machine memory (Turning off power
deletes data input from the computer.)
G After turning the machine off, wait for at least about 10 seconds before
turning it back on again. Wait until the machine completes its power up
routine before trying to print.

Connecting directly to a computer with an IEEE1284 cable

<Available only if the Parallel Interface Kit is installed>
1
Find the machine's parallel port.
❍
The parallel port is located on the left side of the machine.
2
Plug one end of the IEEE1284 cable into the machine's parallel port.
3
Install a printer driver on your computer.
❍
See "Installing a Windows Printer Driver" on page 2-1.
4
Connect the other end of the IEEE1284 cable to the computer's
parallel port.
❍ See the documentation that came with your computer for
information about where its parallel port is located.
1-8
Status Meaning
On LAN connection is normal.
Off Power is turned off.
LAN connection is not normal.
Flashing Data send or receive is in progress.
On 100Mbps operation
Off 10Mbps operation
Printer Controller Pi3505e Pi3505e/PS
Before Using the Printer Driver