Konica Minolta PK-517 Installation Manual

A10E-9550-01E.fm 1 ページ ２００９年７月２日 木曜日 午後６時２３分
PK-517
INSTALLATION MANUAL
I. Accessory parts
No. Name Shape Q'ty
1. Punch unit
1
A10EIXC001DA
2. Punch box
1
A10EIXC002DA
3. Label
1
4512IXC053DA
4. Installation
manual
1
set
4980IXC019DA
After unpacking, be sure to get rid of the
packaging materials and keep them out of
the reach of children.
Putting the head in the plastic bag
involves danger of suffocation.
Note:
This manual provides the illustrations of the acces-
sory parts and machine that may be slightly different
in shape from yours. In that case, instead of the
illustrations, use the appearance of your machine to
follow the installation procedure. This does not
cause any significant change or problem with the
procedure.
Punch Kit
Applied Machine: FS-527
II. Installation procedures
Note:
When mounting the punch kit, mount it before
mounting the finisher to the machine.
1. Turn off the machine and unplug the power cord
from the power outlet.
2. Remove the protective tape.
A10EIXC003DA
3. If the finisher is mounted on the machine, remove
the finisher.
Note:
For the finisher removal procedure, see installa-
tion manual for finisher.
4. Remove the exit tray from the finisher.
A10EIXC004DA
A10E-9550-01
E-1
5. Remove the upper cover from the finisher (four 8. Open the cover of the finisher as shown in the
screws). illustration and place the punch kit on the finisher.
A10EIXC005DB
6. Remove the plate from the finisher as shown in
the illustration (two screws).
9. Connect the punch kit connector to the finisher.
A10EIXC006DA
7. Remove the plate from the finisher as shown in
the illustration (three screws).
A10EIXC007DA
A10EIXC008DA
A10EIXC009DA