Table of Contents
Advertisement
Configuring PostScript Printer Driver Properties for Windows 98 and Me
I Watermark
I Watermark String
I Watermark Font Typeface
I Watermark Font Size
I Watermark Angle
I Watermark Font Shading
Printer Controller Pi3505e Pi3505e/PS
Note
The Booklet setting is available only when the Hard Disk
Drive Kit (HDD-6) is installed on the machine.
For U.S.A and Canada users only
When using Di2010/Di2010f, the
available only when the Duplex Unit (AD-16) and
Switchback Unit (SB-1) are installed on the machine.
Specify where the watermark should be printed in the
document.
• Off
Watermark is not printed.
• 1st Page
Prints the watermark on the first page only.
Only
• All Pages
Prints the watermark on all the pages of the
document.
Select the text string that you want to use as the watermark.
Available
CONFIDENTIAL, TOP SECRET, COPY, DO
settings:
NOT COPY, DRAFT, FINAL, PROOF
Select the typeface you want to use for the watermark.
The following fonts can be used.
Arial-BoldItalicMT, Arial-BoldMT, Arial-ItalicMT, ArialMT,
Courier, Courier-Bold, Courier-BoldOblique, Courier-Oblique,
Helvetica, Helvetica-Bold, Helvetica-BoldOblique, Helvetica-
Oblique, Times-Bold, Times-BoldItalic, Times-Italic, Times-
Roman
Select a font size in the range of 8 points to 200 points.
Use this setting to specify the angle of the watermark text
relative to the paper, in the range of -90° to +90° (15-degree
steps). A negative (-) value rotates the characters clockwise, 0
specifies the text should be parallel to the paper, and a positive
(+) value rotates the characters counter-clockwise.
Specify the relative density of the watermark text, in the range
of 5% to 100% (10% steps)
Booklet
setting is
6
6-9
Advertisement
Table of Contents
