Table of Contents
Advertisement
Configuring PCL Printer Driver Properties for Windows
(4) Size
Specify a font size in the range of 8 points to 200 points.
(5) Style
Use these settings to turn bold and italic style on or off.
• Bold
• Italic
(6) Shading
Specify the relative density of the watermark text, in the range of
5% to 100%.
(7) Angle
Use this setting to specify the angle of the watermark text relative
to the paper. You can specify Horizontal, Diagonal, Vertical, or
User Setting as the angle.
• User Setting
(8) Position
Specify the position where the watermark text should be printed.
• Center
• User Setting
Printer Controller Pi3505e Pi3505e/PS
Bold text
Italic text
These settings become available when
Setting
them to configure settings that control the angle
of the watermark text. The setting range is -180°
to +180°.
A negative (-) value rotates the characters
clockwise, 0 specifies the text should be parallel
to the paper, and a positive (+) value rotates the
characters counter-clockwise.
Selecting this setting prints the watermark text
in the center of the paper.
After selecting
position by using horizontal and vertical values.
Horizontal: -999 to 999 points
Vertical: -999 to 999 points
(72 points = 1 inch)
Tip
Specify the position from the center. A positive Horizontal value
is to the right, while a positive Vertical value is upward. The
settings you make will be reflected in the dialog box's preview
image.
is selected for the angle setting. Use
User
Setting, you can specify a
4
User
4-31
Advertisement
Table of Contents
