Initial Set Mode Items - Icom IC-78 Instruction Manual

4
SET MODE
n

Initial Set mode items

• RF/SQL control action
Selects the [RF/SQL] control action from RF/squelch, automatic (acts as a
squelch in AM modes and an RF in SSB/CW/RTTY modes), or the squelch only.
(See page 14)
The default is Sq (squelch).
• Beep
A beep sounds to confirm each time a switch is pushed. This function can be
turned OFF for silent operation.
The default is on.
• Beep level
Adjusts the confirmation beep level from 1 to 99.
The default is 50.
• Side-tone level
Adjusts the CW side-tone level from 1 to 99.
The default is 30.
• Meter peak hold
Selects the meter peak hold function on or off.
The default is on.
• Scan speed
Sets the scanning speed to High or Low.
The default is HI (High).
• Scan resume
Turns the scan resume function ON or OFF.
ON: Resumes 10 seconds after stopping on a signal
(or 2 seconds after a signal
OFF: Does not resume after stopping on a signal.
disappears).
The default is on.
• AM Noise blanker
When set to ON, the noise blanker function is selectable in the AM mode. This is
useful when communicating in AM
(the noise blanker function should be OFF when lis-
.
tening to regular AM broadcasts as it may degrade the receive audio)
The default is on.
30