Current Time Settings; Time Zone And Dst - D-Link DES-3350SR User Manual

D-Link DES-3350SR Standalone Layer 3 Switch

Current Time Settings

To enable SNTP on the Switch, click SNTP Settings in the Configuration folder and then click Current Time Settings:
Figure 7 - 24. Current Time window
To use SNTP, toggle the SNTP State in the Current Time: SNTP Settings section to Enabled and enter the IP address of the relay
the SNTP Primary Server and/or the SNTP Secondary Server. Enter an SNTP polling interval in the bottom field. The default
setting of 720 seconds is usually fine for most network configurations; a greater polling frequency will draw more network
resources. Click Apply to let your changes take effect.
To complete SNTP configuration, fill in the desired values in the Current Time: Set Current Time section and then click Apply.

Time Zone and DST

To make time zone and Daylight Savings Time changes to the SNTP configuration, click SNTP Settings in the Configuration
folder and then click Time Zone and DST:
43