Static Arp Settings - D-Link DES-3350SR User Manual

To enter an IP Interface into the Switch's Static/Default Route Settings window, click the Add button, revealing the following
window to configure.
The following fields can be set:
Click Apply to implement changes made.

Static ARP Settings

The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical addresses. This table allows
network managers to view, define, modify and delete ARP information for specific devices. Static entries can be defined in the
ARP Table. When static entries are defined, a permanent entry is entered and is used to translate IP address to MAC addresses. To
open the Static ARP Table open the Configuration folder, and then open the Layer 3 IP Networking folder and click on the
Static ARP Settings link.
To add a new entry, click the Add button, revealing the following screen to configure:
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 9 - 8. Routing Table – Add window
Parameters
IP Address
Subnet Mask
Subnet Mask
Cost(1-65535)
Backup Status
Figure 9 - 9. Static ARP Settings window
Description
Allows the entry of an IP address that will
be a static entry into the Switch's Routing
Table.
Allows the entry of a subnet mask
corresponding to the IP address above.
Allows the entry of a subnet mask
corresponding to the IP address above.
Allows the entry of a routing protocol
metric representing
routers between the Switch and the IP
address above.
The user may choose between Primary
and Backup. If the Primary Static/Default
Route fails, the Backup Route will
support the entry. Please take note that
the Primary and Backup entries cannot
have the same Gateway.
97
the number of