Ingress Checking; The Default Vlan - D-Link DES-3350SR User Manual

D-Link DES-3350SR Standalone Layer 3 Switch
Ports with tagging enabled will put the VID number, priority and other VLAN information into the header of all packets that flow
into and out of it. If a packet has previously been tagged, the port will not alter the packet, thus keeping the VLAN information
intact. The VLAN information in the tag can then be used by other 802.1Q compliant devices on the network to make packet
forwarding decisions.
Ports with untagging enabled will strip the 802.1Q tag from all packets that flow into and out of those ports. If the packet doesn't
have an 802.1Q VLAN tag, the port will not alter the packet. Thus, all packets received by and forwarded by an untagging port will
have no 802.1Q VLAN information. (Remember that the PVID is only used internally within the switch). Untagging is used to
send packets from an 802.1Q-compliant network device to a non-compliant network device.

Ingress Checking

A port on a switch where packets are flowing into the switch and VLAN decisions must be made is referred to as an ingress port. If
ingress filtering is enabled for a port, the switch will examine the VLAN information in the packet header (if present) and decide
whether or not to forward the packet.
If the packet is tagged with VLAN information, the ingress port will first determine if the ingress port itself is a member of the
tagged VLAN. If it is not, the packet will be dropped. If the ingress port is a member of the 802.1Q VLAN, the switch then
determines if the destination port is a member of the 802.1Q VLAN. If it is not, the packet is dropped. If the destination port is a
member of the 802.1Q VLAN, the packet is forwarded and the destination port transmits it to its attached network segment.
If the packet is not tagged with VLAN information, the ingress port will tag the packet with its own PVID as a VID (if the port is a
tagging port). The switch then determines if the destination port is a member of the same VLAN (has the same VID) as the ingress
port. If it does not, the packet is dropped. If it has the same VID, the packet is forwarded and the destination port transmits it on its
attached network segment.
This process is referred to as ingress filtering and is used to conserve bandwidth within the switch by dropping packets that are not
on the same VLAN as the ingress port at the point of reception. This eliminates the subsequent processing of packets that will just
be dropped by the destination port.
The "Default" VLAN
The switch initially configures one VLAN, VID = 1, called the "default" VLAN. The factory default setting assigns all ports on the
switch to the "default" VLAN.
Packets cannot cross VLANs. If a member of one VLAN wants to connect to another VLAN, the link must be through an external
router.
If no VLANs are configured on the switch, then all packets will be forwarded to any destination port. Packets with unknown
destination addresses will be flooded to all ports. Broadcast and multicast packets will also be flooded to all ports.
The 802.1Q Port Settings window, shown below, allows you to determine whether the switch will share its VLAN configuration
information with other GVRP (GARP VLAN Registration Protocol)-enabled switches. In addition, Ingress Checking can be used
to limit traffic by filtering incoming packets whose PVID does not match the PVID of the port.
To view the 802.1Q Port Settings window, open the Configuration menu, click on VLAN, and then click the Port VLAN ID
(PVID).
39