Dhcp / Bootp Relay; Dhcp / Bootp Relay Information - D-Link DES-3350SR User Manual

Specify the host route settings and click the Apply button to add or change the settings. The new settings will appear listed in the
OSPF Host Route Settings list. The following fields are configured for OSPF host route.
Parameters

DHCP / BOOTP Relay

The BOOTP hops count limit allows the maximum number of hops (routers) that the BOOTP messages can be relayed through to
be set. If a packet's hop count is more than the hop count limit, the packet is dropped. The range is between 1 and 16 hops, with a
default value of 4. The relay time threshold sets the minimum time (in seconds) that the Switch will wait before forwarding a
BOOTREQUEST packet. If the value in the seconds field of the packet is less than the relay time threshold, the packet will be
dropped. The range is between 0 and 65,536 seconds, with a default value of 0 seconds.

DHCP / BOOTP Relay Information

To enable and configure BOOTP or DHCP on the Switch, click Configuration > DHCP/BOOTP Relay > DHCP/BOOTP Relay
Information:
The following fields can be set:
Parameters
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 9 - 36. OSPF Host Route Settings - Add
Host Address
Metric
Area ID
Figure 9 - 37. DHCP/ BOOTP Relay Global Settings window
Description
BOOTP Relay State
BOOTP Relay Hops
Count Limit (1-16)
BOOTP Relay Time
Threshold (0-65535)
Description
The IP address of the OSPF host.
A value between 1 and 65535 that will be
advertised for the route.
A 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF
domain.
This field can be toggled between Enabled
and Disabled using the pull-down menu. It
is used to enable
BOOTP/DHCP Relay
Switch. The default is Disabled
This field allows an entry between 1 and 16
to define the maximum number of router
hops BOOTP messages can be forwarded
across. The default hop count is 4.
Allows an entry between 0 and 65535
seconds, and defines the maximum time
limit for routing a BOOTP/DHCP packet. If
120
or disable the
service on the