Unpacking And Setup; Unpacking; Installation; Desktop Or Shelf Installation - D-Link DES-3350SR User Manual

Unpacking and Setup

Unpacking

Installation

Power On
This chapter provides unpacking and setup information for the Switch.
Unpacking
Open the shipping carton of the Switch and carefully unpack its contents. The carton should contain the following items:
•
One DES-3350SR Stackable layer 3 Switch
•
Mounting kit: 2 mounting brackets and screws
•
Four rubber feet with adhesive backing
•
One AC power cord
•
This User's Guide with Registration Card
If any item is found missing or damaged, please contact your local D-Link reseller for replacement.
Installation
Use the following guidelines when choosing a place to install the Switch:
•
The surface must support at least 5 kg
•
The power outlet should be within 1.82 meters (6 feet) of the device
•
Visually inspect the power cord and see that it is secured to the AC power connector
•
Make sure that there is proper heat dissipation from and adequate ventilation around the switch.
•
Do not place heavy objects on the switch

Desktop or Shelf Installation

When installing the Switch on a desktop or shelf, the rubber feet included with the device should first be attached. Attach these
cushioning feet on the bottom at each corner of the device. Allow adequate space for ventilation between the device and the objects
around it.

Rack Installation

The DES-3350SR can be mounted in an EIA standard-sized, 19-inch rack, which can be placed in a wiring closet with other
equipment. To install, attach the mounting brackets on the switch's side panels (one on each side) and secure them with the screws
provided.
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 2 - 1. Installing rubber feet for desktop installation
Section 2
5