Admin And User Privileges; Save Changes - D-Link DES-3350SR User Manual

1. Enter the new user name, assign an initial password, and then confirm the new password. Determine whether the new user
should have Admin or User privileges.
2. Click Apply to make the user addition effective.
3. A listing of all user accounts and access levels is shown in the User Account Management window. This list is updated
when Apply is executed. Click Show All User Account Entries to access this window.
4. Please remember that Apply makes changes to the switch configuration for the current session only. All changes
(including User additions or updates) must be entered into non-volatile ram using the Save Changes command on the
Main Menu - if you want these changes to be permanent.

Admin and User Privileges

There are two levels of user privileges: Admin and User. Some menu selections available to users with Admin privileges may not
be available to those with User privileges.
The following table summarizes the Admin and User privileges:
After establishing a User Account with Admin-level privileges, go to the Maintenance menu and click Save Changes. Next click
Save Configuration. The switch will now save any changes to its non-volatile ram and reboot. You can logon again and are now
ready to continue configuring the Switch.

Save Changes

The DES-3350SR has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective by clicking the Apply button. When this is done, the settings will be immediately applied to the switching software in
RAM, and will immediately take effect.
Some settings, though, require you to restart the switch before they will take effect. Restarting the switch erases all settings in
RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM before
rebooting the switch.
To retain any configuration changes permanently, click Save Changes from the Maintenance menu. The following window
will appear:
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 6 - 3. User Account Modify Table window
Switch Configuration
Management
Configuration
Network Monitoring
Community Strings and Trap Stations
Update Firmware and Configuration Files
System Utilities
Factory Reset
Reboot Switch
User Account Management
Add/Update/Delete User Accounts
View User Accounts
Table 6-1. Admin and User Privileges
Privilege
Admin User
Yes Read Only
Yes Read Only
Yes Read Only
Yes Read Only
Yes Ping Only
Yes
Yes
Yes
Yes
17
No
No
No
No