Ping Test; Save Changes; Reboot Services - D-Link DES-3350SR User Manual

D-Link DES-3350SR Standalone Layer 3 Switch

Ping Test

Ping is a small program that sends data packets to the IP address you specify. The destination node then returns the packets to the
switch. This is very useful to verify connectivity between the switch and other nodes on the network.
Figure 11 - 6. Ping Test window
The Infinite times checkbox, in the Repeat Pinging for section, tells PING to keep sending data packets to the specified IP
address until the program is stopped.

Save Changes

The DES-3350SR has two levels of memory, normal RAM and non-volatile or NV-RAM.
To retain any configuration changes permanently, highlight Save Changes on the Maintenance menu. The following screen will
appear to verify that your new settings have been saved to NV-RAM.
Figure 11 - 7. Save Configuration window
Once the switch configuration settings have been saved to NV-RAM, they become the default settings for the switch. These
settings will be used every time the switch is rebooted.

Reboot Services

The following folder contains windows that allow you to either Reboot, Reset, Reset System, or Reset Config. See the on-screen
instructions for the differences among each option.
Note that all changes are kept in normal memory. If a user does not save the result into NV-RAM with the Save Changes function,
the switch will recover all the settings the last user configured after the switch is rebooted.
153