Then, use the screws provided with the equipment rack to mount the switch on the rack.
Power on
The DES-3350SR switch can be used with AC power supply 100 - 240 VAC, 50 - 60 Hz. The power switch is located at the rear of
the unit adjacent to the AC power connector and the system fan. The switch's power supply will adjust to the local power source
automatically and may be turned on without having any or all LAN segment cables connected.
After the power switch is turned on, the LED indicators should respond as follows:
•
All LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system
•
The power LED indicator is always on after the power is turned ON
•
The console LED indicator will blink while the Switch loads onboard software and performs a self-test. It will remain ON
if there is a connection at the RS-232 port, otherwise this LED indicator is OFF
Power Failure
As a precaution in the event of a power failure, unplug the switch. When the power supply is restored, plug the switch back in.
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 2 - 2. Attaching the mounting brackets to the switch
Figure 2 - 3. Installing the switch on an equipment rack
6