Parameters Description - D-Link DES-3350SR User Manual

Go to the Configuration folder, and click on the Layer 3 IP Networking folder, and then click on the IP Interfaces Settings link to
open the following dialog box:
To setup a new IP interface, click the Add button. To edit an existing IP Interface entry, click on an entry under the Interface Name
heading. Both actions will result in the same screen to configure, as shown below.
Enter a name for the new interface to be added in the Interface Name field (if you are editing an IP interface, the Interface Name
will already be in the top field as seen in the window above). Enter the interface's IP address and subnet mask in the corresponding
fields. Pull the State pull-down menu to Enabled and click Apply to enter to make the IP interface effective. Use the Save
Changes dialog box from the Maintenance folder to enter the changes into NV-RAM.
The following fields can be set:
D-Link DES-3350SR Standalone Layer 3 Switch
Figure 9 - 1. IP Interface Table window
Figure 9 - 2. IP Interface Settings – Add
Figure 9 - 3. IP Interface Settings - Edit
Parameters
Interface Name
IP Address
Subnet Mask
VLAN Name
Description
This field displays the name for the IP
interface. The default IP interface is
named "System".
This field allows the entry of an IP
address to be assigned to this IP
interface.
This field allows the entry of a subnet
mask to be applied to this IP interface.
This field allows the entry of the VLAN
Name for the VLAN the IP interface
belongs to.
93