Layer 3 Global Settings; Md5 Key Table Settings - D-Link DES-3350SR User Manual

Layer 3 Global Settings

The L3 Global Settings window allows the user to enable and disable Layer 3 settings and functions from a single window. To
view this window, open the Configuration folder and then the Layer 3 IP Networking folder and click on the L3 Global
Settings link to access the following window.
The user may set the following:
Click Apply to implement changes made.

MD5 Key Table Settings

The MD5 Key Table Configuration menu allows the entry of a 16 character Message Digest − version 5 (MD5) key which can be
used to authenticate every packet exchanged between OSPF routers. It is used as a security mechanism to limit the exchange of
network topology information to the OSPF routing domain.
MD5 Keys created here can be used in the OSPF menu below.
To configure an MD5 Key, click the MD5 Key Table Settings on the Layer 3 IP Networking folder.
The following fields can be set:
D-Link DES-3350SR Standalone Layer 3 Switch
State
Figure 9 - 4. Layer 3 Global Settings window
Parameters
DVMRP State
PIM-DM State
RIP State
Figure 9 - 5. MD5 Key Setting and Table window
Parameters
This field may be altered between
Enabled and Disabled using the pull
down menu. This entry determines
whether the interface will be active or
not.
Description
The user may globally enable or disable
the Distance Vector Multicast Routing
Protocol (DVMRP) function by using the
pull down menu.
The user may globally enable or disable
the Protocol Independent Multicast -
Dense Mode (PIM-DM) function by using
the pull down menu.
The user may globally enable or disable
the Routing Information Protocol (RIP)
function by using the pull down menu.
Description
94