Copy; Ping Test; Ipv4 Ping Test - D-Link Xstack DGS-3600 Series User Manual

Copy

This window is used to copy a directory located within the Flash memory of the switch. To view this window, click Maintenance
> CF Services > System Services > Copy. Click Copy to initiate copying the file.
This window offers the following fields to aid the user in copying files located in the Flash memory of the Switch.
Parameter
Unit
Source File (Full Path)
Target File (Full Path)

Ping Test

Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or
"echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the
network.

IPv4 Ping Test

The following window is used to Ping an IPv4 address. To locate this window, open the Administration folder and click Ping
Test > IPv4 Ping Test.
The user may use Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to keep sending
ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific number of
times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255. Click Start to initiate
the Ping program.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 26. Copy File window
Description
Choose the switch in the switch stack where the file exists.
Enter the full path and file name of the directory to be copied. This entry cannot exceed 64
characters in length.
Enter the file name of the directory and the path to place the copy. This entry cannot
exceed 64 characters in length.
Figure 6- 27. Ping Test window
49