Canon imagePROGRAF iPF8400S User Manual page 528

Specifying the Cutting Method for Rolls
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
•
Note
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6
Press ▲ or ▼ to select Manual, and then press the OK button.
7
When "Perform the detection of paper leading edge?" is displayed, select Do not perform.
•
Note
•
8
Press the Feed button.
9
Press ▲ or ▼ to align the paper leading edge with the
(a) position.
528
).
If the Tab Selection screen is not displayed, press the Menu button.
If you set the detection of paper leading edge to Do not perform, a margin of about 10 cm is created at the paper
leading edge when printing starts.
When the detection of paper leading edge is set to Do not perform, printing will start at the position at which the roll
was set for the first printing after replacing a roll. Thus, the margin of the paper leading edge will enlarge.
(See "Loading Rolls in the Printer.")
P.510
➔
iPF8400S
User's Guide