Canon imagePROGRAF iPF8400S User Manual page 649

iPF8400S
System
CarriageScanWdth
Setup
Use RemoteUI
Reset PaprSetngs
Erase High Speed
HDD Da-
ta
Secure High Spd.
Secure
Output Print
Method
Print (Auto Del)
Save: Box XX
Print After Recv
Common Box Set.
Show Job Log
Take-up Use Take-up Reel
Reel
Auto Feed
Skip Take-Up Err
Prep.MovePrinter
Admin. Change Password
Menu
User's Guide
Setting Item Description, Instructions
Specify the scan width of the carriage during printing. Select
Automatic for movement equivalent to the width of paper loa-
ded. Selecting Fixed will reduce any soiling on the back of the
paper, although printing may take a little longer.
Choosing Off prohibits access from RemoteUI. Settings can
only be configured from the control panel.
Restores settings that you have changed with Media Configu-
ration Tool to the default values.
Erases file management data for print job data stored on the
printer's hard disk. (See "Erasing Data on the Printer's Hard
Disk.")
P.669
➔
Overwrites the entire hard disk with random data. (See "Eras-
ing Data on the Printer's Hard Disk.")
Overwrites the entire hard disk with 00, FF, and random data
(one time each). Verification is performed to check if the data
was correctly written. (See "Erasing Data on the Printer's Hard
Disk.")
P.669
➔
Select the printing method for jobs received from software oth-
er than the printer driver. When using the printer driver, config-
ure settings on the printer.
To print as usual, select Print. Selecting Print (Auto Del) will
print the job and then delete the data from the printer's hard
disk. Selecting Save: Box 01 will only save the print job in the
box, without printing it.
A setting for jobs received from software other than the printer
driver. When using the printer driver, configure settings on the
printer. Select On to print the job after it has been saved.
Select Print (Auto Del) to print without saving jobs in the box
shared among multiple users.
Selecting Off prevents display of the log in Job Menu > Job
Log. Additionally, the log is not printed if you choose Job
Menu > Print Job Log. Note that because job logs are not col-
lected, the Status Monitor accounting functions will not work
correctly.
Selecting Enable allows use of the Media Take-up Unit.
Available only if Use Take-up Reel is already set to Enable.
Rolls are automatically advanced to the position for attachment
to the Rewind Spool.
Available only if Use Take-up Reel is already set to Enable.
Choose On to continue with printing even if an error occurs
with the Media Take-up Unit. Choose Off to pause printing if a
take-up error occurs.
When transferring the printer to another location, choose the
level of transfer and follow the instructions on the screen. (See
"Preparing to Transfer the Printer.")
Not displayed during a warning message that the remaining
Maintenance Cartridge capacity is low.
The password that can be entered is a number from 0 to
9999999.
The restriction states and main items are shown below. For
more specific information on restricted items, see "Menu Struc-
ture."
P.635
➔
Menu Settings
P.669
➔
P.911
➔
649