Paprwidth Mismatch; Paper Size Not Detected - Canon imagePROGRAF iPF8400S User Manual

PaprWidth Mismatch

The loaded paper is too small.
(When you have attempted to print a test print sheet
or other printer status information.)
"Replace roll with 10 in. wide or larger roll."
The loaded paper is too small.
(When you have attempted to print a test print sheet or other print-
er status information.)
PaprWidth Mismatch
PaprWidth Mismatch
When Detect Mismatch in the Control Panel menu is set
to Pause or Hold Job, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in the
printer driver.

Paper size not detected.

Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.
958
Cause
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Cause
Cause
Cause
Corrective Action
Replace the roll with a roll 10 inches in width or larger as follows.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2. Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quali-
ty.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select Fit
Roll Paper Width in the printer driver matches the width of the roll loaded in the
printer, and then try printing again.
Lift up the Release Lever and reload the paper.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Printer.")
If "Not finished printing. Finish printing re-
maining jobs?" is displayed on the Display
Screen, press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Corrective Action
P.517
➔
P.519
➔
P.507
➔
P.510
➔
P.517
➔
P.519
➔
P.507
➔
P.510
➔
Corrective Action
➔
iPF8400S
P.510
P.533
➔
User's Guide