Table of Contents
Advertisement
Chapter 7, Installing Internal Drives
2.
If you are replacing a hard drive, disconnect the power connector and the
SCSI connector from the rear of the hard drive.
hard drive
SCSI connector
3.
If you are replacing a drive, remove the mounting screws of the drive, and
remove the drive. If you are installing a drive, insert the drive into the
RAID rack, and install four mounting screws, two on each side.
4.
If you are Þnished, proceed to ÒPutting the computer back togetherÓ on
page 137.
136
PowerTower Pro UserÕs Guide
For Technical Support, Call 1-800-708-6227
power
connector
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the PowerTower Pro and is the answer not in the manual?
Questions and answers