Power Computing PowerTower Pro User Manual page 108

Chapter 6, Adding Memory
3.
Slide the contacts straight into the slot and make sure the contacts are
Þrmly seated in the slot.
DonÕt force the DIMM module into the slot; if the motherboard starts bending
signiÞcantly, pull the DIMM out, reposition it, and try again.
Note: Some DIMM modules have sharp, square edges which are difÞcult to get into the
DIMM slot. If you have repeated difÞculty getting the DIMM into the slot, return it to your
vendor for replacement.
4.
If the DIMM module is seated, the DIMM lever should rise by itself so it
lines up with the other levers.
5.
When you are Þnished, replace the front 3.5 inch drive bay cage, and re-
connect the drives in the drive cage.
6.
Re-assemble the computer as described in ÒPutting the computer back
togetherÓ on page 83.
82
PowerTower Pro UserÕs Guide
For Technical Support, Call 1-800-708-6227