Table of Contents
Advertisement
Chapter 7, Installing Internal Drives
Software drivers, if required.
1. If you are not proÞcient with electronic equipment, Power Computing
CAUTION!
Corporation recommends that you have a certiÞed technician install
RAM, drives, and expansion cards. If you attempt to install RAM, drives,
or cards yourself, any damage you may cause to your equipment will not
be covered by the limited warranty on your computer. Please call
technical support at 1-800-708-6227 for additional information about this
or any other warranty question.
2. If an anti-static bracelet is available, put it on and ground it to the
computer chassis before touching any components inside the computer.
3. Never turn the computer on or operate the computer with the cover
removed.
Drive bay locations
The PowerTower Pro uses two SCSI (Small Computer Systems Interface) buses to connect
drives; a 10 MB/sec. internal bus and a 5 MB/sec. external bus. For a discussion of how the
SCSI bus on your computer is set up, see ÒUsing SCSI devices,Ó starting on page 16. Pay
particular attention to the discussion of SCSI termination, discussed in ÒEnsuring proper
terminationÓ on page 17.
Besides the ßoppy disk drive, the built-in hard disk, and the CD-ROM drive, the computer
has two front-accessible 5.25-inch drive bays below the CD-ROM drive. Each of these drive
bays allows you to install one full-height or two half-height drives.
96
PowerTower Pro UserÕs Guide
For Technical Support, Call 1-800-708-6227
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the PowerTower Pro and is the answer not in the manual?
Questions and answers