Viewing The Alarm; Alarming On The Avaya S8300 Media Server - Avaya G250 Maintenance Manual

Media Server alarms

Viewing the alarm

The technician views alarms and events through the commands in
Viewing Alarms
interface.
Table 130: Commands for Viewing Alarms
Command
View
Current
Alarms
display
alarms

Alarming on the Avaya S8300 Media Server

S8300 alarms can be tested and corrected using SAT commands or the Web interface. If you
run the Avaya Communication Manager application either from a Telnet session (SAT window)
or Avaya Site Administration, you can use the following SAT commands to obtain more
information.
To obtain information from Avaya Communication Manager alarms:
1. Use display alarms command:
Issuing the display alarms command at the administration terminal shows where
maintenance software has logged alarms. The alarms are a good indication of the cause of
system problems. They should be used in combination with the following.
2. Observe RED LEDs on the media modules to determine if software or firmware had a
problem.
Clear Avaya Communication Manager alarms with various SAT commands and corrective
actions documented in Maintenance Alarms for Avaya Communication Manager 3.0, Media
Gateways and Servers, 03-300430 and Maintenance Procedures for Avaya Communication
Manager 3.0, Media Gateways and Servers, 03-300432.
!
CAUTION:
Only trained Avaya technicians should clear alarms.
CAUTION:
300 Maintenance for the Avaya G250 and Avaya G350 Media Gateways
on page 300, which are available via the Web Interface and SAT command-line
Interface Purpose
Web To view a list of
Interface, outstanding alarms against
under Avaya Communication
Alarms and Manager
Notification
SAT CLI To view logged Avaya
Communication Manager
alarms
Table 130: Commands for
Description
Displays a summary of alarms
(if present), followed by a
detailed table of explanation.
These are the alarms that
have not yet been cleared,
either manually or via an
Expert System.