Description Of Menu 8 Functions - Ikegami HLM-2450WB Operation Manual

4-11．Description of MENU 8 Functions
ＭＥＮＵ８（ＰＡＲＡＬＬＥＬ ＲＥＭＯＴＥ）
１．ＰＩＮ ＦＵＮＣＴＩＯＮ ＤＥＦＡＵＬＴ
Ｐ２：ＣＨ－Ｂ
Ｐ３：（ｂｌａｎｋ） Ｐ１０：１６：９
Ｐ４：Ｇ－ＴＡＬＬＹ Ｐ１１：ＤＶＩ
Ｐ５：ＣＯＭＰ． Ｐ１２：ＭＡＲＫＥＲ
Ｐ６：（ｂｌａｎｋ） Ｐ１３：ＳＨＡＤＯＷ
Ｐ７：ＭＯＮＯ Ｐ１４：Ｒ－ＴＡＬＬＹ
Ｐ８：ＲＧＢ Ｐ１５：ＳＤＩ
（Ｐ１：ＧＮＤ）
ＳＥＴ→ ＥＸＩＴ→
ＥＮＴ
① Setting the functions of parallel remote pins
・Select the pre-assigned pin functions of parallel
remote control or the individual user-set
functions.
* By default, the pre-assigned pin functions are
displayed beneath.
② Setting the IP conversion mode
・When "USER" is selected in ① , set the
individual pin functions.The settable functions
are as follows.
： selection of CH-B
・CH-B
： selection of SDI input
・SDI
： selection of DVI input
・DVI
： selection of component input
・COMP.
： selection of MONO
・MONO
： selection of component RGB
・RGB
input
： selection of SDTV aspect ratio
・16:9
16:9
・EXT SYNC ： selection of external sync input
： marker ON
・MARKER
： shadow ON at MENU7-preset
・SHADOW
level
・SHADOW0 ： shadow ON at shadow level 0%
(Black)
・SHADOW20 ： shadow ON at shadow level
20%
・SHADOW40 ： shadow ON at shadow level
40%
・SHADOW60 ： shadow ON at shadow level
60%
： R tally ON
・R-TALLY
： G tally ON
・G-TALLY
：selection of 3G-SDI input
・3G-SDI
・ANALOG PC：selection of Analog PC input
： unassigned
・(blank)
Ｐ９ ：ＥＸＴ ＳＹＮＣ
E S C
① Setting the functions of parallel remote pins
② Setting the user pin functions
* "SHADOW0 ", "SHADOW20 ",
"SHADOW40 " and "SHADOW60 "
functions
• Select two or more SHADOW settings at once,
and "SHADOW0" (Black) is given priority.
• When any of these functions is turned ON, the
MENU8-adjusted shadow level is forced to go
back to the level remotely preset.
* The functions of the following pins, which are
fixed, cannot be changed.
• Pin 1 : Make contact GND
- -
30