Table of Contents
Advertisement
2-4．Option (CM-175 input/output)
CM-175
① Component (YPbPr/RGB) signal input
・ Feed component signals.
・ Set either YPbPr or RGB on MENU1.
・ When the signal format is 1080i/60 or 1035i/60,
the 1080i/1035 setting must be made on
MENU1.
・ To select this input, set to "OPT." with the
INPUT SELECT switches ( ▲ & ▼ ) on the
front panel. Make sure that the "INPUT
SELECT" on MENU2 or 9 is set at "VIDEO".
For this purpose, it is also possible to assign the
function keys F1 and F2 on the front panel.
2-5．Option (EA-240A output)
EA-240A
①
COMPONENT
Y/G
Pb/B
Pr/R
PC
SYNC
③
②
AUDIO OUT
(ANALOG)
② External sync signal input
・ Feed an external sync signal here when externally
synchronizing component signals.。
・ If not adopting the loop through connection method,
connect the terminating plug.
・ To switch to EXT SYNC, make the setting on
MENU1.
For this purpose, it is also possible to assign the
function keys F1 and F2 on the front panel.
③ Analog PC signal input
・Input the PC signal (analog RGB signal) here.
As for the compatible format, refer to the "Data 1:
PC Input Signal Compatible Format".
・ To select this input, set to "OPT." with the INPUT
SELECT switches ( ▲ & ▼ ) on the front panel.
Make sure that the "INPUT SELECT" on MENU9
is set at "PC".
For this purpose, it is also possible to assign the
function keys F1 and F2 on the front panel.
① Embedded analog audio output
・ Select one pair of channels out of four paired
channels
(eight
multiplexed in SDI) in the MENU6. The selected
①
2-channel analog audio signal is outputted from
this connector.
・ Use XLR-5-11C or equivalent as an output
connector.
・ For details of pin connection, refer to the "Data 2:
Embedded
analog
D3G-240A)".
・ The output is active. When handling the output
unbalanced, use the hot side and ground. (Keep the
cold side open.)
- 7 -
embedded
audio
channels
audio
outputs
(EA-240A/
Advertisement
Table of Contents
