Table of Contents
Advertisement
⑥ Setting the brightness of audio level meter
・Set the brightness of the audio level meter.
・The level meter image transmissive mode or
nontransmissive mode can be set.
・LOW
・MID
・HIGH
・LOW (MIX) (Image transmissive mode)
・MID (MIX) (Image transmissive mode)
・HIGH (MIX) (Image transmissive mode)
・Default setting is HIGH.
⑦ Setting the peak hold display of audio level meter
・Used to turn on and off the peak hold display.
・Default setting is ON.
⑧ Downmix setting
・Set the 5.1 channel surround downmix.
・Mix the 5.1 channel surround audio signal
assigned to 6 channnels of embedded audio into
2 channels and outputs from a speaker or a
headphone.
・5.1ch surround super woofer(LFE) channel is not
mixed.
⑨ Setting the downmix coefficients
・Select the mixing method to downmix 5.1ch audio
in "ISO/IEC" and "ARIB".
・Default setting is ISO/IEC
⑩ Setting the Ls/Rs level
・Set the coefficient of Ls/Rs to mix.
・Set among -3dB/-6dB/-9dB/OFF.
(OFF ＝ －∞)
・Default setting is －3dB
⑪ Setting the embedded audio channel assignment
of speaker (Lm)
・Set the channel of embedded audio, which the
audio for 5.1ch surround Lm speaker (left side in
front) should be assigned from.
・Default setting is CH1
⑫ Setting the embedded audio channel assignment
of speaker (Rm)
・Set the channel of embedded audio, which the
audio for 5.1ch surround Rm speaker (right side
in front) should be assigned from.
・Default setting is CH2
⑬ Setting the embedded audio channel assignment
of speaker (C)
・Set the channel of embedded audio, which the
audio for 5.1ch surround C speaker (center)
should be assigned from.
・Default setting is CH3
⑭ Setting the embedded audio channel assignment
of speaker (Ls)
・Set the channel of embedded audio, which the
audio for 5.1ch surround Ls speaker (left side in
rear) should be assigned from.
・Default setting is CH5
⑮ Setting the embedded audio channel assignment
of speaker (Rs)
・Set the channel of embedded audio, which the
audio for 5.1ch surround Rs speaker (right side
in rear) should be assigned from.
・Default setting is CH6
- -
23
Advertisement
Table of Contents
