Ikegami HLM-2450WB Operation Manual page 29

⑨ Setting the VECTOR SCOPE display ON/OFF
・Used to turn on or off the VECTOR SCOPE
display.
・This function can be assigned with the F1 F2
switch on the front panel.
・Default setting is OFF.
⑩ Setting the VECTOR SCOPE display brightness
・Used to set the VECTOR SCOPE display
brightness in 3 levels: LOW, MID and HIGH.
・Default setting is HIGH.
⑪ Setting the VECTOR SCOPE display
magnification ratio
・Used to set the VECTOR SCOPE display
magnification in 4 ratios: x1, x2, x4 and x8.
・Default setting is x1.
⑫ Setting the COLOR BOX scale display
・Used to set the VECTOR SCOPE' s COLOR BOX
according to the input color bar signal: 75% and
100%.
・Default setting is 100%.
75%SCALE
⑬ Setting the VECTOR SCOPE display position
⑭ Setting the VECTOR SCOPE display color
100%SCALE
- -
19
・Used to set the waveform display to any of the
RIGHT, CENTER and LEFT positions.
・When used commonly with WFM, the VECTOR
display is located on the left of the WFM one.
・Default setting is RIGHT.
・RIGHT location
VECTOR
・CENTER location
VECTOR
・LEFT location
VECTOR
・Used to set the waveform display color to either of
GREEN and WHITE.
・Default setting is WHITE.
VECTOR
WFM
VECTOR
WFM
VECTOR
WFM