Rear Panel ( Video Inputs/Outputs) - Ikegami HLM-2450WB Operation Manual

2-3．Rear panel (video inputs/outputs)
①
②
③
④
① DVI-D signal input
・ This connector is used to connect the DVI-D
signal from the PC.
・ The compatible formats are referred to in "7-2
Rated performance (6)".
② SDI A/B signal input
・ Input the HD-SDI or SD-SDI (4:2:2) signal here.
・ The format of input signal is automatically
identified.
③ SDI signal output
・ Output the same selected channel signal from
the A/B channel as channel select is made for
monitoring.
④ NTSC/PAL-B analog composite input
・Input the NTSC/PAL-B analog composite (VBS)
signal here.
・ Without the loop through connection in place,
connect a terminating plug.
⑤ PARALLEL REMOTE signal input
・ Connect the accompanying remote connector
here.
・ For details of pin connections, refer to "Data 3:
Parallel Remote
Description of MENU 8 Functions".
・ Make sure the cable used is shielded.
DVI
HD/4:2:2
SDI
CH A
CH B
MONITOR
OUT
VBS
CH A
CH B
Pin Function" or "4-11.
REMOTE
PARALLEL
TEST
SERIAL
IN
RS-485
OUT
L
AUDIO
R
⑥ SERIAL REMOTE signal input
・ Connect the BNC cable from the SRC-301A/Z serial
remote controller here.
・ By adopting the loop through connection, up to 99
monitors can
collectively.
・ Without the loop through connection in place,
connect a terminating plug.
・ Set the monitor ID number on the MENU2 screen.
⑦ RS-485 input/output
・ These are used for remote control with RS-485.
・ Up to 32 units can be loop-through-connected.
・ Without loop-through connection, use the optional
terminating device.
※ Make sure the cable used is shielded.
⑧ Analog audio input
・Feed analog audio signals here.
⑨ TEST terminal for factory adjustment
・ The TEST terminal is factory adjustment. Connect
nothing to this terminal.
- 6 -
⑤
⑨
⑥
⑦
⑧
be controlled individually or