Menu Controls And Functions; Picture Settings - Ikegami ULE-217A Instruction Manual

MENU CONTROLS AND FUNCTIONS

1. Picture Settings

Brightness
- used to control brightness(offset) level from 0 to 100
- shown in grey as it can be controlled by front knobs without entering the menu
Contrast
- used to control contrast(gain) level from 0 to 100
- shown in grey as it can be controlled by front knobs without entering the menu
Chroma
- used to control chroma(saturation) level from 0 to 100
- shown in grey as it can be controlled by front knobs without entering the menu
Aperture
- used to control sharpness level from 0 to 24 (0 for smooth and 24 for edge)
- ULE-217A recommend to use internal pattern edge for easier selection
NTSC Setup
- used to control the difference black level when NTSCJ for Japan is used
- used for component signal only
Advanced
- used for VGA input only
1) Auto Adjustment
- used to turn on and off automatic position of VGA input by controlling phase and
clocks/line
- it can be controlled using Auto key on front
2) Image Position
- used to move the position manually for VGA input
- 10 -