Figure 1.12 Popup For [Allow Virtual Console] In Second Terminal Pc; Figure 1.13 Popup For [Allow Only Video] In Second Terminal Pc; Figure 1.14 Popup For [Deny Access] In Second Terminal Pc; Figure 1.15 Popup For Timeout In First Terminal Pc - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 1 Network Environment Setup and Tool Installation
1.6 Management Tool Operating Conditions and Use
- Display in third terminal
If you try to open video redirection in third terminal PC, the dialog box instructing that connect again
after closing other video redirection since the number of connection reaches the maximum of
permitted number for video redirection.

FIGURE 1.16 Popup for reaching maximum number of connection in second terminal PC

Console redirection
PRIMEQUEST 2000 series provides console redirection to route serial output from partitions via a LAN.
Console redirection conforms to the specifications of IPMI v2.0 SOL (Serial Over LAN).
When you perform console command with the partition specified on MMB CLI, console output to the COM
port on the partition is redirected. Input from the terminal is reported to the COM port on the partition.
Connection period of text console redirection
Console redirection is automatically disconnected after a certain idle time. You can set automatic
disconnection time, timeout value, by console command.
For details on console command, see '2.2.4 console' in "PRIMEQUEST 2000 series Tool Reference" (C122-
E177).
How to connect console redirection
Note
If console redirection is disconnected due to timeout, below message appears.
"You have exceeded your idle time limit. Logging you off now."

FIGURE 1.12 Popup for [Allow Virtual Console] in second terminal PC

FIGURE 1.13 Popup for [Allow only video] in second terminal PC

FIGURE 1.14 Popup for [Deny Access] in second terminal PC

FIGURE 1.15 Popup for TIMEOUT in first terminal PC

20
C122-E175-02EN