Table 5.5 Confirmation Of Interface Names - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 5 PCI Card Hot Maintenance in SUSE Linux Enterprise Server 11
5.1 Hot Replacement of PCI Express Cards
:
:
The ¥ at the end of a line indicates that there is no line feed.
c. Reflect the edited rules again.
Repeat the process done in step 10 to reflect the rules.
# udevadm control ––reload-rules
d. Power on the PCI Express slot.
Repeat the process done in step 11 to power on the PCI Express slot.
The interfaces created for the replacement NIC may be active because power is on to the PCI
Express slot. At this stage, since we recommend proceeding with the work with the interface on the
replaced NIC deactivated, repeat the operation in step 13.
e. Collect the information about interfaces on the NIC again, and create a table.
Use the same procedure as in step 3 to update the interface name information in the table from step
14 showing the correspondence of the interface before and after NIC replacement.
Note
Confirm that each specified interface name is the same as before the NIC replacement.
Interface name
eth0
eth1
...
17. Edit the saved interface configuration file.
Write a new hardware address to replace the old one. In "HWADDR," set the hardware address of the
replacement NIC in
and after NIC
under bonding, the file contents are partly different, but the lines to be set are the same.
(Example)
DEVICE=eth0
NM_CONTROLLED=no BOOTPROTO=static HWADDR=00:0E:0C:70:C3:40
BROADCAST=192.168.16.255
IPADDR=192.168.16.1
NETMASK=255.255.255.0
NETWORK=192.168.16.0
ONBOOT=yes
TYPE=Ethernet
Do this editing for all the saved interfaces.
18. Restore the saved interface configuration file to the original file.
Restore the interface configuration file saved to the save directory to the original file by executing the
following command.
# cd /etc/sysconfig/network/temp
# mv ifcfg-ethX
(following also executed for bonding configuration)
# mv ifcfg-bondX
19. Activate the replaced interface.
The method for activating a single NIC interface differs from that for activating the SLAVE interfaces
under bonding.
[For a single NIC interface]
Execute the following command to activate the interface. Activate all the necessary interfaces.
# /sbin/ifup ethX
Also, if the single NIC interface has a VLAN device and the VLAN interface was temporarily removed,
restore the VLAN interface. If the priority option has changed, set it again.
# /sbin/vconfig add ethX Y
# /sbin/ifup ethX.Y
(enter command to set VLAN option as needed)

TABLE 5.5 Confirmation of interface names

Hardware address
00:0e:0c:70:c3:40
00:0e:0c:70:c3:41
...
'TABLE 4.9 Example of entered values corresponding to the interface names before
replacement'' or 'TABLE 4.5 Hardware address description
..
..
Bus address
0000:0b:01.0
0000:0b:01.1
...
135
Slot number
20
20
...
examples'. Also, for SLAVE
C122-E175-02EN