Connecting The Mmb Console Pc; Figure 3.1 External Views Of Mounting Locations And External Interface Of Mmb; Table 3.2 External Interface Of Mmb; Table 3.3 Contents Of Setting Of Terminal Software - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.3 Connection and Setting of MMB

3.3.1 Connecting the MMB console PC

This section describes the connection of the MMB and MMB console PC.
There are two methods of connecting MMB with MMB console PC.
- Connect the COM port of the MMB console PC and the External interface RS232C (COM port) of the MMB with
RS232C cross cable.
- Connect the LAN port of the MMB console PC and the External interface MAINTENANCE LOCAL (LAN port) of the
MMB with LAN cable.
Remark
- In PRIMEQUEST2400E/2800E/2800B, only way of
- In PRIMEQUEST2400E2/2800E2/2800B2, both ways can be used.
For the mounting location and external interface overview of the MMB, refer to the figure below.

FIGURE 3.1 External Views of Mounting Locations and External interface of MMB

External interface
RS232C(COM Port)
LAN 1000Base- T
LAN 100Base-TX
Set the terminal software by using following contents, at the time of connecting COM port,
Bit/ second
Data bit
Parity
Stop bit
Flow control
Emulation

TABLE 3.2 External interface of MMB

Quantity
1 Used by the field engineer when setting-up the device. It is not used in
normal operations.
2 User port
2 Maintenance
-[LOCAL] : CE Port
-[REMOTE]: REMCS Port

TABLE 3.3 contents of setting of terminal software

Setting item
RS232 (COM port) can be used.
Remark
Value
19200
8
No
1
No
VT100
12
CA92344-0536-04