Fujitsu PRIMEQUEST 2000 Series Administration Manual page 103

CHAPTER 4 PCI Card Hot Maintenance in Red Hat Enterprise Linux 6
4.5 IOU hot remove
0000:83:09.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:84:00.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:02.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:08.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:09.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:10.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:11.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:89:00.0 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:89:00.1 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8c:00.0 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8c:00.1 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8f:00.0 Fibre Channel: Emulex Corporation Saturn-X:
LightPulse
Fibre Channel Host Adapter (rev 03)
0000:8f:00.1 Fibre Channel: Emulex Corporation Saturn-X:
LightPulse
Fibre Channel Host Adapter (rev 03)
NIC on the IOU (including onboard NIC)
The procedure describes operations where a single NIC is configured as one interface. It also describes
cases where multiple NICs are bonded together to configure one interface (bonding configuration). For
bonding multiple NIC by using PRIMECLUSTER Global Link Services (GLS), see 'PRIMECLUSTER Global
Link Service Configuration and Administration Guide Redundant Line Control Function' (J2UZ-7781).
Notes
- To perform hot replacement in a system where a bonding device is installed, design the system so that it
specifies ONBOOT=YES in all interface configuration files (the /etc/sysconfig/network-scripts/ifcfg-
eth*files and the /etc/sysconfig/network-scripts/ifcfg-bond*files), regardless of whether the NIC to be
replaced is a configuration interface of the bonding device.
An IP address does not need to be assigned to unused interfaces. This procedure is for preventing the
device name of the replacement target NIC from being changed after hot replacement. If ONBOOT=NO
also exists, the procedure described here may not work properly.
1. Confirm where the NIC is mounted.
Confirm the correspondence between PCI Address and interface name of NIC mounted in the IOU which
is confirmed by above "dr show IOU" command.
Example: When PCI Address is "0000:89:00.0".
79
C122-E175-02EN