Figure 1.8 Message Of Requesting Access To Virtual Console In Second Terminal Pc; Figure 1.9 Popup Window Of [Virtual Console Sharing Privileges]; Figure 1.10 Popup For [Allow Virtual Console] In First Terminal Pc; Figure 1.11 Popup For Timeout In First Terminal Pc - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 1 Network Environment Setup and Tool Installation
1.6 Management Tool Operating Conditions and Use
- Display of video redirection window remains black or 'No Signal'.
- Error dialog of video redirection appears and any operation cannot be performed.
- Window of video redirection is disconnected unintentionally.
Below description is how to connect video redirection.
1. First terminal PC is connected to a partition by video redirection with Full Virtual Console Access.
2. If you connect to same partition by video redirection, a massage requesting permission to virtual console
access appears in second terminal PC.

FIGURE 1.8 Message of requesting access to Virtual Console in second terminal PC

3. In first terminal PC, window where connection privilege of second terminal PC is selected appears. Select
connection privilege from below.
- Allow Virtual Console
permit Full Virtual Console access where all operation of video redirection can be performed.
- Allow only Video
permit only video where display function of video redirection can be performed.
- Deny Access
deny access to video redirection.
If thirty seconds passes, [Allow Virtual Console] is selected.
4. Popup which shows result selected by first terminal PC.
- Display in first terminal PC.
Such below window is displayed depending on result of selection except for [Allow only Video].
- Display in second terminal PC.
Result selected by first terminal PC is shown below in second terminal PC.

FIGURE 1.9 Popup window of [Virtual Console Sharing Privileges]

FIGURE 1.10 Popup for [Allow Virtual Console] in first terminal PC

FIGURE 1.11 Popup for TIMEOUT in first terminal PC

19
C122-E175-02EN