Load The Last Setup - Fourier MultiLogPRO User Manual


3. Use the Forward
the sensor in input 1 and then press the Enter button
arrow indicator will move to the second input.
4. Repeat this procedure with all the sensors you plugged in.
5. After the fourth sensor has been selected, the screen will list the
next 4 sensors:

You can press the Enter button in the last input if you want to go back to the
first input.
6. When you've finished selecting the sensors press the Escape
button
and you must complete the setup, as detailed in section 6.2.3.
Note: When you turn the MultiLogPRO off it will save the setup for the next
session.

6.2.8 Load the Last Setup

Input – 1
Input – 2
Input – 3
Input – 4
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
and Backward
Input – 5
Input – 6
Input – 7
Input – 8
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
. The arrow indicator will point to the Rate command
arrows to select
. The
MultiLogPRO 75