Quick-Start - Fourier MultiLogPRO User Manual

6.2.3 Quick-Start

1. Turn on MultiLogPRO
Plug the supplied AC/DC 9 - 12V adaptor into MultiLogPRO (see page 59), then
plug it to the mains. You will see the initialization screen. MultiLogPRO performs
a brief self-check and displays its status including battery level, and then loads
the last setup you used (see page 75). Wait until you see the Main Menu
screen:
2. Plug in the sensors
Start with the first input on the right. If MultiLogPRO is in Auto ID mode (the
default mode) it will display the setup menu and will identify the sensors you've
plugged in.
Input – 1
Input – 2
Input – 3
Input – 4

Note: Sensors must be added successively, starting with input-1. If a single
sensor is used it must be connected to I/O-1. If two sensors are used in
an experiment, they must be connected to I/O-1 and I/O-2.
Microphone
Light
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
MultiLogPRO 63