Programming Multilogpro - Fourier MultiLogPRO User Manual

7. Wait until the main menu is displayed on MultiLogPRO's LCD
screen, then press Enter
8. Close the Weather Station main box and lock it by fastening the two
plastic screws on the upper and lower right sides of the box

4.2.15 Programming MultiLogPRO

MultiLogPRO ships already programmed to the Weather Station default
setup. When turned on it uploads the last setup. To operate the Weather
Station in the default mode there is no need to program MultiLogPRO.
You can, however, change the setup to meet your special needs. You
can add or replace sensors, select another sampling rate and choose
definite sampling period.
The Default setup
Sensors:
Input 1:
Input 2:
Input 3:
Input 4:
Rate:
Operating mode:
Saving interval:
You can program MultiLogPRO either from the MultiLogPRO keypad or
via the WeatherLab software
Note: In wireless mode, transmission is one way only, from
MultiLogPRO to the computer. Therefore if you are using wireless
connection you need to connect MultiLogPRO to the computer with
the supplied communication cable in order to program it
20 Station Installation
Rain
Wind speed
Humidity
No sensor
Every 10 seconds
Continuous
Every 15 minutes
to begin sending data
Input 5: No sensor
Input 6: Temperature
Input 7: Wind direction
Input 8: Pressure