Connecting The Weather Station To The Computer; Wireless Connection - Fourier MultiLogPRO User Manual

Setting up MultiLogPRO prior to operating it in a wireless connection
Note: If you wish to operate your Weather Station in its default mode
there is no need to set MultiLogPRO up, simply proceed to Section
4.2.16 instructions
1. Disconnect MultiLogPRO from the Weather Station main box
2. Connect MultiLogPRO to the supplied AC – DC adaptor and plug
the adaptor to the mains
3. Connect MultiLogPRO to the computer with the supplied
communication cable
4. Turn on MultiLogPRO by pressing the On button on MultiLogPRO
keypad
5. Open WeatherLab
6. Setup the Weather Station (see on page 35)
7. Wait until setup is complete
8. Disconnect MultiLogPRO from the mains and from the computer
and replace it in the Weather Station main box

4.2.16 Connecting the Weather Station to the Computer

A. Wireless Connection
Connect the receiver to the computer (see Chapter 7 on page 84 to learn more
about the receiver):
1. Place the receiver near the computer and connect the serial
communication cable:
A. Connect the stereo phone jack to the RS-232 socket at the bottom
of the receiver
B. Connect the type D 9-pin plug to an available serial COM port on
your PC
Station Installation 21