Fourier MultiLogPRO User Manual page 37

Data is saved automatically to the computer (The WeatherLab software must be
running continuously).
The user sets the saving intervals and the sampling rate (see on page 35).
The saved data is the average of all samples that were recorded since the
previous save, except the wind direction and rainfall.
In this mode the MultiLogPRO does not save data, and can keep logging as
long the station is running.
Stand-alone experiment
Use this mode if you want to operate the Weather Station in a remote outdoor
location.
Data is saved in the MultiLogPRO.
In this mode the recording time is restricted by the sampling rate and the logger
memory (104,000 samples).
To setup your station to the default setup
1. Turn the MultiLogPRO unit on and connect it to the PC via USB
cable
2. The MultiLogPRO should be automatically detected. There will be
a message in the lower bottom left corner of the WeatherLab
software
Note: Depending on the firmware version of your MultiLogPRO unit,
you may see a different version listed then the screenshot above
3. Click Logger on the menu bar, and then click Setup.
WeatherLab 31